Standard

BS 7346-8 / EN 12101

Weekly test

Site team, logged

Full service

Annually minimum

Common fault

Actuator and battery failure

On this page
Talk to an engineer

01726 839333

Mon–Fri 8am–5pm. 24/7 emergency line out of hours.

01

Smoke Ventilation Overview

Smoke ventilation clears smoke from common corridors and stairs so residents can escape and firefighters can get in. In residential blocks it is the system that makes a stay-put or phased strategy viable, and if it does not operate the whole strategy fails.

It is also mechanically the most neglected fire system in most buildings. Actuators seize, control panel batteries die, vents get painted shut, and because nothing tests itself, nobody knows until it is needed.

We service automatic opening vents, natural smoke shafts, mechanical smoke extract and the control panels behind them. Every service includes a functional test of the vent under panel command, actuator condition, battery load test, and confirmation that the vent physically travels its full opening.

Cause and effect matters here. Vents should operate from the right detector on the right floor, and on many sites the wiring has been altered over the years so the wrong vent opens. We verify the sequence rather than just proving the vent moves.

Weekly testing is a site responsibility, and it is simple — a key switch test and a look. We set the logbook up and train whoever will do it, so the record exists when the fire service or your insurer asks.

Smoke vent and control panel service
02

Servicing & Testing

Functional testing

Every vent operated under panel command and confirmed to open fully and reset.

Cause and effect check

Verification that the correct vent responds to the correct detector or call point.

Actuator servicing

Condition, travel and fixings checked; seized or failing actuators replaced.

Control panel & batteries

Panel fault checks and standby battery load testing, with replacement on failure.

Mechanical extract

Fan operation, dampers, ductwork condition and control interface checks.

Logbook & training

Weekly test procedure documented and site staff shown how to run and record it.

03

How it works

1

Asset survey

Vents, shafts, panels, actuators and interfaces recorded per core and per floor.

First visit

2

Full functional service

Everything operated, sequence verified, batteries load tested, findings recorded.

On the visit

3

Report and remedials

Certificate issued with priced remedials for anything that failed or is degrading.

Within 10 days

4

Ongoing regime

Annual service scheduled and weekly site testing set up with a logbook.

Ongoing
04

What gets tested, and by whom

Check
Frequency
Who
Key switch / manual test
Weekly
Site team, logged
Visual condition check
Monthly
Site team, logged
Full functional service
Annually
Recall engineer, certified
Cause and effect verification
Annually or after alteration
Recall engineer

Some insurers and managing agents require six-monthly servicing on higher-risk residential blocks — we will schedule to whichever is stricter.

05

Your legal duty

The Regulatory Reform (Fire Safety) Order 2005 requires fire safety measures, including smoke control, to be maintained in efficient working order. Systems are designed and maintained to BS 7346-8 and the BS EN 12101 series, and form part of the fire strategy relied on in Approved Document B.
RRO 2005
BS 7346-8
BS EN 12101
Approved Document B
06

Why choose Recall

Frequently asked

Our vents have never been serviced. Is that a problem?

Yes, and it is extremely common. First service typically finds seized actuators or dead panel batteries. Better to find that now than during an incident.

Largely. Vent operation is quiet; the disruption is access to communal areas and the roof. We schedule daytime visits and notify residents in advance.

AOVs are vents that open to let smoke out naturally, usually at the head of a stair or shaft. Mechanical extract uses fans and ductwork, and is used where natural venting cannot achieve the required performance.

Yes — dampers, actuators and their control interface are part of the service where a shaft system is fitted.

Do your smoke vents actually open?

One functional service answers that, with a certificate to prove it.